PSM E36 Sway Bar Reinforcement YSRBENZ Old school never does

Old school never does

0 male Male M10 to -3 male goes to the OEM master's rear brake output and -3 steel braided line (which connects to the inlet on the end of the wilwood cylinder) Female m10 to -3 male goes to the oem brake line that you took out of the OEM master and -3 steel braided line (which connects to the outlet on the top of the wilwood cylinder) -3 male to 7/16-20 male goes to the larger fitting in the wilwood cylinder and -4 aluminum crush washer seals the connection -3 male to 3/8-24 male goes to the smaller wilwood cylinder fitting and -3 aluminum crush washer seals the connection 90 degree fittings both attach to the -3 side of the two above fittings and the other end to the braided lines

is sold separately

** If using with solid subframe and diff mounts

If you're running an engine that sits further back then the cross member most likely won't work

PSM E36 Sway Bar Reinforcement YSRBENZ Old school never doesListing is for: 1x Set of reinforcement plates Our 1 8" steel pates weld in to the E36 non M rear subframe to prevent the swaybar tabs from ripping off due to using aftermarket swaybars. The second bolt hole is specifically for our 2 bolt bar mounts although its compatible with any swaybar mount. Fits perfectly because of the 3D scanned and laser cut design. Sold as a set of 4 pieces.