JET Milling Y-Axis Table Powerfeed XM18 The cast iron construction gives

The cast iron construction gives the table exceptional strength

The 14-1/2 inch table tilts up to 45 degrees for angled sanding

230V Single Phase – 50" Rip (PM1-PM25150WKT)

this shaper is housed in a fully enclosed cabinet stand that adds weight and stability while also keeping dust and debris contained

Your Go-To Kit for Knife Sharpening

JET Milling Y-Axis Table Powerfeed XM18 The cast iron construction givesJET Milling Y Axis Table Powerfeed The JET Milling Y Axis Table Powerfeed attaches to the Y axis of your JET milling machine and drives table movement at a controlled, consistent rate. It takes over the manual feed so you can focus on the cut rather than the handle. The built in clutch protects the machine if the table reaches an overload condition. Adjustable stops let you set automatic shutoff points for repeatable travel limits. Continuously